Oki B8300 - Manual (Page 68)

Duplex module — 67
Setting the printer driver for duplex
module, bypass tray and exit tray
When using the duplex module (including the
bypass tray and the exit tray) for printing,
select “Properties” and make selections as
follows for the print job.
The screens used in the following descriptions
are for a PCL driver in the Windows 98
environment.
Two-sided printing
Open the “Main” tab and check the radio
button of the desired two-sided printing mode.
Using the bypass tray
Open the “Paper” tab shown in the illustration
below and select “Bypass Tray” in the “Paper
Selection” drop down.
Using the exit tray mounted to the duplex
module
Open the “Paper” tab shown in the illustration
below and select “Left Side Tray” in the
“Output” drop down.
The settings screens shown will appear only if
the devices have been set properly in the
printer driver configuration.
The combination of paper selection and other
functions may not be compatible. For instance,
if heavy paper, envelopes, label stock, etc. are
selected, it will not be possible to select
duplex, offset tray, saddle stitch, etc.