Oki B8300 - Manual (Page 85)

Saddle stitch finisher — 84
10. Remove the staple box.
11. Raise the lever at the end of the staple
box. Remove the top staple if it is bent. If
bent staples remain, a staple jam will
occur again.
12. Return the lever to its original position.
13. Reinstall the staple box. Push the staple
box in until it clicks into place.
14. Push the stapler section back into the
finisher.
15. Close the front cover.
16. Push the saddle stitch finisher back
against the printer.
Make a test print in the staple sort mode to
ensure that stapling is performed properly.
Disposal of hole punch scrap
1. Unlatch the saddle stitch finisher and
slide it away from the printer.
2. Pull out the punch scrap collecting
container and empty it.
3. Return the punch scrap collecting
container to its original position.
4. Push the saddle stitch finisher back
against the printer.