Oki B8300 - Manual (Page 42)

41 — Job control
8. Verify that the desired number of copies is
set.
COPIES
10 SET
The number of copies can be changed by using
the or key on the operator panel.
9. Press the [OK] key.
Printing will start. If printing of another job is
being executed, however, your job will be
registered as a print job. Printing of the job will
start after preceding jobs are completed.
10. Operation is now complete.
11. To continue operation, repeat steps 1 to 9.
Printer account control
If the key operator program Auditing Mode is set, the number of printed pages can be totalled for each
account. The accounts for auditing are accounts that have been established with a key operator program
for counting the number of pages from the printer.
When executing a print operation from the computer, you must enter an account number on the setting
screen of the printer driver.The account number entry screen will be displayed by clicking [Job Control] in
the [Main] tab of the printer driver.
When an invalid account number is entered or no account number is entered, if key operator program
[Cancel jobs of invalid accounts] has been set, printing will not be performed.To perform printing in any
case, disable the program [Cancel jobs of invalid accounts]. In this case, the number of printed pages will
be accumulated in [OTHERS].
The job control screen will always appear when a print operation is executed from the printer driver if the
[Auto Job Control Review] check box in the [Main] tab of the printer driver is set.