Oki B8300 - Manual (Page 32)

Overview — 31
Developer cartridge replacement
When the cartridge needs replacing, a message
indicating the need to replace it will appear in
the display. Follow the procedure below to
replace the developer cartridge. The machine
as shipped from the factory does not have a
cartridge installed.
Follow the procedure below to install the first
cartridge omitting steps 3 and 4.
1. Turn off the power and open the front
cover.
2. Lower the cartridge lock lever.
3. Remove the developer cartridge. Push the
lock release button and pull out the
developer cartridge until it stops.
4. Push the lock button at the rear and
remove the developer cartridge.
5. Remove the new developer cartridge from
its bag and remove the tape and
protective material A and B.
6. Shake the new developer cartridge
horizontally five or six times.
7. Insert the new developer cartridge.
8. Push the cartridge in until it locks
securely into place.
9. Close the front cover. The machine will
become available in about two minutes.
● Do not shake the developer cartridge after the
sealing tape has been removed. If the cartridge
is shaken after the tape is removed, some
developer will come out of the cartridge.
B
A