Oki B8300 - Manual (Page 78)

77 — Finisher
Troubleshooting finisher problems
Check the list below before calling for service.
Problem Check Cause or solution or
Stapling position is not
correct. Stapling position not set correctly? Check the stapling position setting.
The finisher does not
operate. Are any finisher covers open? Close all covers.
Message indicating need to remove paper from the stapler
compiler displayed? Open the finisher and
remove all paper from
the stapler compiler.
Stapling cannot be
performed. Is a [CHECK THE STAPLER UNIT] or [CHECK STAPLER POSITION
OR STAPLE JAM] message displayed? Check the staple unit.
Is a message [ADD STAPLES] displayed? Replace the staple cartridge.
Different size paper included? Stapling cannot be performed on to
different size paper.
Stapled sets are not stacked
correctly or some sheets in
a set are not stapled. Paper heavily curled? Paper may be curled heavily depending
on the paper type and quality.
Remove paper from the paper tray or the
bypass tray, turn it upside down, and
load it again.