Oki B8300 - Manual (Page 40)

39 — Job control
JOB CONTROL
This section describes the operation procedure
required for this function. To use job control in
your print job, select [Properties] on the printer
driver screen, open the [Main] tab and click [Job
Control.] The job hold function can be used only
if your printer is equipped with the hard disk
drive option.
Job control operation
1. Normal print
(In this mode, no input from the operator panel
of the printer is needed.)
The print setting in this mode is the basic print
operation. If no problem occurs with the printer
(such as paper misfeed or toner out), the print
start operation is completed on the computer
and printing will be executed on the printer.
2. Hold after print
In this mode, print data will be held in the Hold
Job List even after printing is complete. Printing
can be executed again from the operator panel
of the printer if needed. Also, the data can be
deleted from the operator panel if it is not
necessary.
3. Hold before print
This mode can reduce the possibility of missing
printout. If printing is made in this mode from the
computer, print data will not be output
immediately and will be stored in the printer as
a held job until released from the operator panel.
A print start operation can be made on the
operator panel of the printer as needed. You
can also delete the data without executing
printing.
4. Proof print
This mode can prevent a high-volume misprint
when many sets must be printed. If printing is
executed in this mode, only one set will be
printed and the remaining sets will be held as a
hold job.
After checking the finished printout, including
print position on paper and stapling position,
you can start printing of the remaining sets
from the operator panel of the printer. You can
also delete the data without executing printing.
5. Password (5 digits)
If a password is set in the printer driver setting,
a password entry is needed to start printing of
a password protected job. This mode can
increase the security of hold jobs.
● Hold After Print mode with password:
Password entry on the operator panel of the
printer is needed to allow additional printing
of held job.
● Hold Before Print mode with password:
Password entry on the operator panel of the
printer is needed to start printing.
● Proof Print mode with password:
Password entry on the operator panel of the
printer is needed to allow the printing of the
remaining sets after printing one set. The first
set is printed without password entry.
Password
Password