Oki B8300 - Manual (Page 17)

Overview — 16
1. Printer
2. Upper exit tray extension
Mount this unit to the upper paper
exit tray. This extension is needed to
support large size paper.
3. Finisher (B83F)
Output sheets can either be sorted in
page order or grouped by page.
Sorted sets or groups are offset
stacked for easy separation when
removed. Sorted sets can be
delivered either stapled or
unstapled.
4. Mail-bin stacker (B83MB)
This unit is an output sorter that has
seven receiving bins. The bin to
receive printed output can be
selected in the printer driver. Each
bin can be assigned to receive
printed output by an individual
person or by groups of people so
that their prints are separated from
other users making them easy to
retrieve.
When this unit is installed, any
copies will be sent to the top tray
and not to the mail bins.
5. Stand/MPD and 2000 sheet paper
drawer (B83LT)
This paper feed unit contains an
upper multi-purpose drawer (see
item 6 ) and a lower drawer which
can hold a maximum of 2000 sheets
of 80 g/m
2
(20 lb) paper.
6. Multi-purpose drawer (B83MP)
Up to 500 sheets of 80 g/m
2
(20 lb)
paper can be loaded. Special papers
such as envelopes (standard sizes
only) and postcards can also be set.
7. Stand/3 x 500 sheet paper drawer
(B83TT)
This paper feed unit contains an
upper multi-purpose drawer (see
item 6) and two lower drawers each
of which can hold a maximum of 500
sheets of 80 g/m
2
(20 lb) paper.
8. Saddle stitch finisher (B83SS)
The saddle stitch finisher can
automatically place two staples for
centreline binding of prints or copies
and fold them along the centreline.
An optional hole punching unit is
available for installation into the
finisher.
9. Duplex module (B83D)
An optional duplex module must be
installed for automatic two-sided
printing.
10. Duplex module/bypass tray (B83DB)
This module is basically the same as
above with the addition of a manual
bypass paper feed unit.
11. Mounted to the paper output port of a
duplex module.
Some peripheral devices cannot be installed together while others may require the installation of
one or more others to be functional.
See Chapter 6, List Of Combination Of Peripheral Devices.
Other optional equipment (not shown)
120 or 240V power supply unit (B83PS).
The voltage will depend upon the region in which the product is used.
Some peripheral devices require the installation of this power supply.
Hard disk drive (B83HD).
Extends the printer’s image storing capacity.
This unit is required for the job retention function to operate.
2-hole punch (B83THP).
2-3 hole punch (B83USP).
4-hole punch (B83FHP).
4-hole broad-space punch (B83FBP).