Oki B8300 - Manual (Page 56)

55 — Key operator programs
I/O timeout
This program is used to set the length of time to
wait for an I/O to complete a job on the parallel
port or the network port.
If the data stream to the port does not transmit
data for a length of time exceeding the timeout,
the job will cancel and the next job will start
processing.
The allowable range of the time is 1 to 999
seconds.
Port switching
This program is used to set the switching
method of the parallel port and network port
of this printer.
Network settings
These programs are set when this product is
used as a network printer.
After each program is set, exit the key operator
program, turn off the main switch, and then
turn on the main switch again after a while. The
program that has been set will be effective at
this time.
> Before setting and modification of any
network settings, be sure to consult your
network administrator.
IP address setting
When using this product on a network that uses
the TCP/IP protocol, use this program to set the
IP address (IP address, IP subnet mask, and IP
gateway) of this product. The program is set to
ENABLE DHCP by factory default setting, which
has the IP address setting obtained
automatically. When using this product on a
network that uses the TCP/IP protocol, also set
the program
Enable TCP/IP.
Enable TCP/IP
When using this product on a network that uses
the TCP/IP protocol, set this program. Also set
the IP address using the program
IP address
setting.
Enable NetWare
When using this product on a network that uses
the Novell NetWare protocol, set this program.
Enable EtherTalk
When using this product on a network that uses
the EtherTalk protocol, set this program.
Enable NetBEUI
When using this product on a network that uses
the NetBEUI protocol, set this program.
Reset the NIC
This program is used to reset all configurable
items of the NIC to their factory default
settings.
Setting item Description
PER JOB After a print job is completed,
automatic port selection state
will be restored.
TIMEOUT After I/O timeout time elapses,
automatic port selection state
will be restored.
PARALLEL OFF Printing from the parallel port is
disabled.
NETWORK OFF Printing from the network port is
disabled.