Oki B8300 - Manual (Page 54)

53 — Key operator programs
Operator panel settings
These programs are used to adjust the display
on the operator panel.
Auto clear setting
The auto clear function will return the printer to
standby mode or job status mode after a
programmed length of time has elapsed
without any operation on the operator panel.
Auto clear will not function when the printer is
in configuration setting mode, custom setting
mode or key operator program setting mode.
The auto clear time can be set to 15, 30,
60 seconds or off.
Message display time
This program is used to adjust the time that
messages are displayed (for messages that
automatically disappear).
The time can be set to 3, 6, 9 or 12 seconds.
Language setting
This program is used to switch the language of
messages displayed on the operator panel. The
following languages can be selected.
English, French, and Spanish
Use this program to enable or disable the
sounding of beeps. Beeps will be sounded
when any key is touched and when a
communication error has occurred. The beep
volume can be set in either of two levels. The
default setting is alarm beeps enabled.
Device settings
These programs are used to enable or disable
the use of a peripheral device.
Disable duplex unit
This program is used to disable duplex printing
when the duplex module malfunctions. If this
program is set, only one-sided printing can be
performed.
Disable stapler unit
This program is used to disable stapling when
the stapler unit of the finisher or saddle stitch
finisher malfunctions.
Disable paper desk drawers
This program is used to disable use of the
stand/3
x 500 sheet paper drawer or stand/
MPD and 2000 sheet paper drawer when it
malfunctions.
Disable finisher
This program is used to disable use of the
saddle stitch finisher or finisher when it
malfunctions.
Disable mail-bin stacker
This program is used to disable use of the mail-
bin stacker when it malfunctions.
Saddle stitch adjust
This program is used to adjust the stapling
position (folding position) when using the
saddle stitch function of the saddle stitch
finisher. The value can be adjusted in 0.1 mm
increments within ±3.0 mm from the reference
position for each paper size.
This program is used to set print speed priority,
which is available when printing in offset mode
using the saddle stitch finisher. When this
program is on, a slight decrease in stacking
performance might occur.
Print key operator programs list
This program is used to print out the list of the
key operator programs.
1
2
12
11
Min. -3 mm Max. +3 mm
Reference position
Position adjusted
to the plus
direction Position adjusted
to the minus
direction