Oki B8300 - Manual (Page 7)

Before you do anything please read this — 6
BEFORE YOU DO ANYTHING PLEASE READ THIS
Installation requirements
Due to the complexity and requirement for parts alignment, this machine must be installed by a suitably
qualified Engineer unless the configuration being is installed is the printer unit and the 500-sheet multi-
purpose tray (B83MP) only.
Improper installation may damage this product. Please note the following during initial installation and
whenever the machine is moved.
A small amount of ozone is produced within the printer during operation. The emission level is
insufficient to cause any health hazard.
The present recommended long term exposure limit for ozone is 0.1 ppm (0.2 mg/m
3
) calculated as an
eight-hour time-weighted average concentration. However, since the small amount that is emitted may
have an objectionable odour, it is advisable to place the printer in a ventilated area.
1. The machine should be installed near an
accessible power outlet for easy connection.
2. Be sure to connect the power cord only to a
power outlet that meets the specified
voltage and current requirements. Also
make certain the outlet is properly
grounded.
3. Do not install your machine in areas that are:
● damp, humid, or dusty
● exposed to direct sunlight
● poorly ventilated
● subject to extreme temperature
or humidity changes, e.g., near an air
conditioner or heater.
4. Be sure to allow the required space around
the machine for servicing and proper
ventilation.
80cm 60cm
60cm
30cm