Oki B8300 - Manual (Page 57)

Key operator programs — 56
Initialize/store settings
The configuration settings and the system
settings of the key operator programs can be
stored in memory and be recalled from memory
if the settings are changed. These can also be
reset to the factory default settings.
Restore factory defaults
This program is used to reset configuration
settings , default settings and interface
settings of the key operator programs to the
factory default settings. If you wish to record
the settings before resetting them, use
List
Print of custom settings to print the settings
before using this program.
Store current configuration
Use this program to store the current
configuration settings, default settings and
interface settings of the key operator program
in the printer’s non-volatile memory. To recall
the stored settings, use the program
Restore
configuration.
Restore configuration
Use this program to recall the configuration
settings that have been stored in the printer’s
non-volatile memory by the program S
tore
current configuration.
> After this program is set, exit the key
operator program, turn off the main
switch, wait at least three seconds and
then turn on again. The program will now
be effective.
> If the settings of Enable TCP/IP, Enable
NetWare, Enable EtherTalk or Enable
NetBEUI have been changed, exit the
program, turn off the main switch, wait at
least three seconds and then turn on
again. The changes will now be effective.
Key Operator Code
The following is the factory setting of the Key
Operator Code Number, which must be used to
access the Key Operator program.
Factory setting — 00000
This number must be entered when accessing
the Key Operator Program for the first time.
The Key Operator Code Number is an important
security number allowing the Key Operator to
configure the printer’s functions and auditor’s
settings.
You should register your own code number —
different from the factory setting above —
immediately after your machine is installed.