Omron CS1W-ETN21 - Manual (Page 96)

71
Send Mail Section 3-7
Mail
trigger
type
(Select
only
one.) Soft-
ware
switch If this option is selected, mail is sent whenever the
Mail Send Switch turns ON.
The Mail Send Switch is bit 03 of word n in the
words allocated for CPU Bus Units. (n = 1500 + 25
x unit number)
Checked
Word
value
change If this option is selected, the value of a specified
address is compared with a standard comparison
value using one of the following comparison func-
tions, and mail is sent whenever the condition is
satisfied.
=, <>, <, <=, >=, >
Select the address for storing the comparison
value from the drop-down list.
Not checked
Bit value
change If this option is selected, mail is sent whenever a
specified bit turns ON or whenever it turns OFF.
Select the bit address from the drop-down list
below.
Not checked
ETN
condition If this option is selected, mail is sent whenever a
new error is stored in the Ethernet Unit's error log. Not checked
CPU
condition If this option is selected, mail is sent whenever any
of the following conditions occur at the CPU Unit.
The drop-down list at the right can be used to
select which of these three are to serve as mail
triggers.
• When a non-fatal error occurs
• When a fatal error occurs
• When the operating mode is changed
Not checked
Interval
time
(Peri-
odic
timer) If this option is selected, mail is sent at fixed time
intervals.
The time interval (in minutes) can be set in the
interval time box.
Not checked
Mail address Select the destination mail address.
The mail destination is the one set under the Mail
Address tab.
Address 1
Send user data If this option is selected, user-created data is sent
in the body of the mail.
The location for storing the user-created data is
set by the user-defined mail address setting
below.
Not checked
Send Error Log
information If this option is selected, the error log is included in
the body of the mail. Not checked
Send status infor-
mation If this option is selected, status information is
included in the body of the mail. Not checked
Send file data/I/O
memory data If this option is selected, any of the following types
of data can be sent as file attachments to e-mail.
• I/O memory data (.IOM)
• I/O memory data (.TXT)
• I/O memory data (.CSV)
• File data (any file)
Select the type of data to be attached from the
checkboxes below. If I/O memory data is selected,
then also select, in “I/O memory data” below, the
address and range of data to be sent.
Not checked
Attached file
name If the above setting is checked so that files can be
sent as attachments, then specify the name of the
file that is to be sent. None
Item Contents Default