Installing the new main unit, To remove a rack-mounted main unit, To remove a wall-mounted main unit – Nortel Networks BCM50 User Manual
Page 177: To remove a desktop mounted main unit
Chapter 21 Replacing a main unit
177
Installation and Maintenance Guide
To remove a rack-mounted main unit
1
Ensure you remove all the cables from the main unit.
If necessary, see the procedure
2
If a unit is mounted to the top of the main unit, slide that unit forward until it disengages from
the clips on the main unit. Lift the unit off of the top of the main unit.
3
If the main unit is secured to the rack-mount shelf with screws, remove these screws from the
bottom of the rack-mount shelf.
4
Slide the main unit forward until it disengages from the clips on the rack-mount shelf.
5
Lift the main unit off of the rack-mount shelf and set it on a flat, clean, static-free surface.
6
To remove a wall-mounted main unit
1
Ensure you remove all the cables from the main unit.
If necessary, see the procedure
2
Lift the main unit until it disengages from the clips on the wall-mount bracket.
3
Pull the main unit out and away from the wall-mount bracket.
4
Set the main unit on a flat, clean, static-free surface.
5
Installing the BCM50 unit on the wall
To remove a desktop mounted main unit
1
Ensure you remove all the cables from the main unit.
If necessary, see the procedure
2
If a unit is mounted to the top of the main unit, slide that unit forward until it disengages from
the clips on the main unit. Lift the unit off of the top of the main unit.
3
Lift the main unit off of the table and set it on a flat, clean, static-free surface.
4
Continue with the procedure
To install the BCM50 unit on a desktop or shelf
Installing the new main unit
Use one of the following procedures to install the new BCM50 main unit:
•
Installing the BCM50 unit on the rack-mount shelf
•
To install the BCM50 unit on the wall-mount bracket
•
To install the BCM50 unit on a desktop or shelf
After you install the new BCM50 main unit, proceed to the procedure