Nortel Networks BCM50 - Manual (Page 132)

132 Chapter 13 Using Telset Administration to set the basic parameters
NN40020-302
To select the region
Set the Region using Feature **PROFILE from a two-line display telephone.
For information about using Telset Administration to set this parameter, see the Telset
Administration Guide.
To select the telephony startup template and start DN
Set the Template and Start DN using Feature **STARTUP from a two-line display telephone.
For information about using Telset Administration to set this parameter, see the Telset
Administration Guide.
Configure other telephony startup parameters using Feature **CONFIG. For more information,
see the Telset Administration Guide.
To initialize voice mail
Initialize your voice-mail system using Feature 983 from a two-line display telephone.
For information about using Telset Administration to initialize your voice mail system, see the
CallPilot Telephone Administration Guide.
To create Telset user accounts
1 Select Feature 9*8 from a two-line display telephone.
2 Enter the following user ID and password:
User ID: SETNNA
Password: CONFIG
The numerical values of the user ID and password are 738662 and 266344, respectively.
3 Press NEXT to scroll through the menu and select User Accounts.
4 Press OK. The Accounts screen appears.
5 Press CHNGE to create an account.
6 Press NEXT to scroll through the list of available accounts to create.
7 Press CRT to create the account.
If you see the DEL command instead of the CRT command, then the account already exists.
Note: This is available for only 15 minutes after the system starts.
Note: You can create Telset accounts using only Telset Administration. To
create Element Manager accounts, you must use Element Manager.