NEC EXPRESS5800/100 SERIES N8100-1635F - Manual (Page 65)

Configuring Your Modular Server 4-13
Peripheral Configuration Submenu
IMPORTANT: Make sure to avoid any conflict in the interrupt
requests or the base I/O addresses. If an assigned value is already used
by another resource, it appears in yellow. Any yellow value must be re-
assigned.
Option Parameter Description Your Setting
Serial Port B Disabled
[Enabled] Specify whether serial port B is
enabled or disabled.
Base I/O Address [3F8h]
2F8h
3E8h
2E8h Specify the base I/O address for
serial port B.
Interrupt IRQ 3
[IRQ 4] Specify the interrupt request
(IRQ) for serial port B.
USB 2.0 Controller Disabled
[Enabled] Specify whether the USB 2.0
controller is enabled or disabled.
Serial ATA Disabled
[Enabled] Specify whether the onboard
SATA controller is enabled or
disabled.
SATA AHCI [Disabled] The AHCI (Advanced Host
Controller Interface) is always
disabled on this system. This
option is view only.
This menu appears only when
[Serial ATA] is enabled.
[ ]: Factory-set