NEC EXPRESS5800/100 SERIES N8100-1635F - Manual (Page 60)

4-8 Configuring Your Modular Server
Main
Option Parameter Description Your Setting
System Time HH:MM:SS Shows the current time.
System Date MM/DD/YYYY Shows the current date.
Hard Disk Pre-
Delay Disabled
3 seconds
[6 seconds]
9 seconds
12 seconds
15 seconds
21 seconds
30 seconds When accessing the SATA hard disk
drive for the first time during POST,
the system waits for the specified time
until the hard disk drive becomes
ready.
SATA Port 0 Information Shows the information on the device
connected to each channel, on the
submenu. The settings of some items
may be changed. However, leave the
items as factory-set.
Processor
Settings N/A
Language [English]
Français
Deutsch
Español
Italiano Select which language BIOS SETUP
displays.
[ ]: Factory-set
IMPORTANT: Check and adjust the system clock before the
operation if any of the following conditions is applicable.
„
After carriage of device
„ After storage of device
„ After the device is entered into the pause state under the
environmental condition enduring device operation (temperature:
10°C - 40°C, humidity: 20% - 80%)
Check the system clock at the rough rate of once per month. When the
system clock is installed in a system requiring high time precision, it is
recommended to use a time server (NTP server).
If the system clock is remarkably delayed or advanced as the passage of
time in spite of adjustment, contact your service representative for
maintenance.