NEC EXPRESS5800/100 SERIES N8100-1635F User Manual
Page 120
7-30 Troubleshooting
Fail to access the hard disk drive:
Is the hard disk drive applicable to the modular server?
→ Operation of any device that is not authorized by NEC is not guaranteed.
Is the hard disk drive properly installed?
→ Check if the hard disk drive is properly connected to the internal SAS/SATA cable
connector.
Fail to start the OS:
Is the BIOS configuration correct?
→ Run the BIOS SETUP utility to change the boot order (see Chapter 4).
Is a floppy disk in the floppy disk drive?
→ Take out the floppy disk and restart the modular server.
A message "Floppy disk is not ready" appears even the floppy disk has been inserted in the
external USB floppy disk drive.
A message "Floppy disk is write-protected" appears even the floppy disk in the USB floppy
disk drive is not write-protected.
It is not a failure.
→ Retry several times.
Inserted the correct DVD/CD-ROM but the message like the following is displayed:
The DVD/CD-ROM is not inserted or the
wrong DVD/CD-ROM is inserted.
Please insert the correct DVD/CD-ROM.
OK
Is the data side of the DVD/CD-ROM dirty or damaged?
→ Take the DVD/CD-ROM out of the optical disk drive, make sure that it is not dirty
or damaged, set it back again and click [OK].