NEC EXPRESS5800/100 SERIES N8100-1635F - Manual (Page 123)

Troubleshooting 7-33
Problems with NEC EXPRESSBUILDER
When the modular server is not booted from the NEC EXPRESSBUILDER DVD, check the
following:
‰ Did you set the NEC EXPRESSBUILDER during POST and restart the modular
server?
→ If you do not set the NEC EXPRESSBUILDER during POST and restart the
modular server, an error message will appear or the OS will boot.
‰ Is BIOS configuration correct?
→ The boot device order may be specified with the BIOS SETUP utility of the
modular server. Use the BIOS SETUP utility to change the boot device order to
boot the system from the optical disk drive first.
‰ Is the connected Flash FDD or inserted floppy disk formatted?
→ Make sure that the Windows recognizes that the connected Flash FDD or inserted
floppy disk is formatted. If not, format it.
Problems with NEC ESMPRO
→ For detailed explanations on NEC ESMPRO, refer to the online document stored
in the NEC EXPRESSBUILDER DVD that comes with your N8141-49F Module
Enclosure (1way).