NEC EXPRESS5800/100 SERIES N8100-1635F - Manual (Page 54)

4-2 Configuring Your Modular Server
Starting SETUP Utility
Powering on the modular server starts POST (Power On Self-Test) and displays its check results. If
the NEC logo is displayed, press Esc.
After a while, the following message appears at bottom left on the screen. The message depends on
the status of your modular server.
Pattern 1:
Press to enter SETUP
Pattern 2:
Press to enter SETUP or to Network
Pattern 3:
Press to resume, to enter Setup, to Network
* The message depending on the status of modular server.
Press F2 to start the SETUP utility and display its Main menu.
If you have set a password with the SETUP utility, the password entry screen appears.
Enter the password.
Enter password:[ ]
Password entry is accepted up to three times. If you fail to enter the correct password for three
consecutive times, the modular server halts. (You can no longer proceed.) Power off the modular
server.
NOTE: The modular server is provided with two levels of password:
Supervisor and User. With the Supervisor password, you can view and
change all system parameters. With the User password, system
parameters available for viewing and changing are limited.