NEC EXPRESS5800/100 SERIES N8100-1635F - Manual (Page 58)

4-6 Configuring Your Modular Server
Security
To set passwords on the BIOS level
Select [Security] – [Set Supervisor Password] and enter a password.
Set Supervisor password first, then User password.
To enable/disable the POWER/SLEEP switch feature
Select [Security] – [Power Switch Inhibit] – [Disabled]
(POWER/SLEEP switch is enabled).
Select [Security] – [Power Switch Inhibit] – [Enabled]
(POWER/SLEEP switch is disabled).
To set this item, the Supervisor and User passwords must have been set.
IMPORTANT: Even if [Power Switch Inhibit] is set to [Enabled], the
forced shutdown (see Chapter 7) is still available.
External Devices
To set up external devices
Select [Advanced] – [Peripheral Configuration] and set up each device.
Internal Devices
To set up LAN controller of the modular server
Select [Advanced] – [PCI Configuration] – [Onboard NIC] and set up each device.
To clear the hardware configuration data (after installing/removing internal devices)
Select [Advanced] – [Reset Configuration Data] – [Yes] and reboot the system.
Saving the Configuration Data
To save the BIOS configuration data
Select [Exit] – [Exit Saving Changes] or [Save Changes].
To discard changes to the BIOS configuration data
Select [Exit] – [Exit Discarding Changes] or [Discard Changes].
To resume the default BIOS configuration data (may differ from factory-set value)
Select [Exit] – [Load Setup Defaults].
To save the current settings as user-defined configuration
Select [Exit] – [Save Custom Defaults].
To load the user-defined configuration data
Select [Exit] – [Load Custom Defaults].