Panasonic WJ-SX 150A - Manual (Page 80)

83
■ Put a file to SX150A
Pressing this button will start the putting of the configuration
file from the PC to the unit.
● How to Display
To display this window, click on the (Put to
SX150A) button in the main window (p. 80).
● Parameters
The file name of the configuration data appears.
(OK) button
To put the configuration file from the PC to the unit, click on
this button.
(Cancel Exit) button
To cancel the putting of the configuration file from the PC to
the unit, click on this button.
Notes:
• The setup file has been configured at the factory, and
the file names appear on the main window's title bar.
• Put the file from the PC to the unit when the time with no
necessary to the continuous system operation, such as
after-hours. After the file putting, the system will auto-
matically restart. Then, the system controllers will tem-
porarily log out.
• To change a file, select a file again. (Refer to p. 101
Select Setup Data File.)
• The configuration file cannot be put to the unit while
opening SETUP MENU.
• It takes a few seconds to put a file to SX150A, and you
might assume the PC has been freezing.
Wait until the message “Completed!” appears on the
screen. If the message “Connection error” appears, the
PC is incorrectly connected to the unit. Confirm the set-
tings of WJ-SX150A Administrator Console and retry the
file putting.
(Refer to p. 74 CAMERA/DATA 1-4 PORT and p. 102
Communication Port.)
■ Get a Configuration Data from
SX150A
Pressing this button will start the getting of the configuration
data from the unit to the PC.
● How to Display
To display this window, click on the (Get from
SX150A) button in the main window (p. 80).
● Parameters
The file name of the configuration data appears.
(OK) button
To get the configuration data from the unit to the PC, click
on this button.
(Cancel Exit) button
To cancel the getting of the configuration data from the unit
to the PC, click on this button.
Notes:
• The configuration data getting is also possible during
the surveillance, for it will not interfere with the system
operation.
• The past data will be overwritten when getting a new
configuration data.
• To change the getting directory, select it. (Refer to p.
101 Select Setup Data File.)
• When the file getting has been successfully executed,
“Completed!” will appear. If “Connection Error”
appears, confirm the connection and the serial port set-
ting of the PC and the unit. (Refer to p. 74
CAMERA/DATA 1-4 PORT and p. 102 Communication
Port.) If “Failed!” appear, retry the file getting.