Panasonic WJ-SX 150A - Manual (Page 192)

20
• To skip to the previous/next record during the play-
back, move the JogDial clockwise or counterclock-
wise. (Refer to the recorder’s operating instructions
for the description of record.)
JogDial clockwise: Skips to the previous record.
JogDial counterclockwise: Skips to the next
record.
• To display the spot picture, press the numeric but-
ton corresponding to the desired camera number,
then press the CAM (SET) button. Then, the active
camera number will appear on the LCD.
• To resume the multiscreen display, press the MULTI
SCREEN button.
• To change the number of multiscreen segments,
press the MULTI SCREEN button again during the
multiscreen display.
3. To stop the playback, press the STOP button. The mon-
itor display will return to the multiscreen display.
● Manual Recording
1. Enter the recorder mode. (Refer to p. 19 Recorder
Mode.)
2. To start recording, press the REC button.
The digital disk recorder will start recording.
3. To stop the recording, hold down the REC button.
Note: Refer to WJ-HD500 Series Operating Instructions
for details and other recording modes.
● Stopping REC ONLY Alarm
Recording
You can stop alarm recording activated by "REC ONLY"
setting of 430 CAMERA/440 ALARM PORT/450 SERIAL
PORT/460 MUX MOTION DET in SETUP MENU or the Alarm
Mode window in WJ-SX150A Administrator Console. (Refer
to the operating instructions of matrix switcher.)
To stop the alarm recording, press the ALL RESET button
while holding down the SHIFT button.
● Search Playback
You can search playback images using the Record List or
Thumbnail Display. Every time you press the SEARCH/T&D
SEARCH button, the monitor display will change as follows.
Live image
→ Date-and-time entry form → Record List →
Thumbnail Display → Live image...
Then, "Search Mode" will appear on the LCD.
• Date-and-time Search Playback
The recorded images can be searched for through the date
and time.
1. Enter the recorder mode. (Refer to p. 19 Recorder
Mode.)
2. Press the SEARCH/T&D SEARCH button. The date-and-
time entry form will appear on the center of the monitor.
Note: The factory default setting is the current date and
time.
3. Press the numeric buttons or +/– button to enter the
desired date and time. The cursor can be adjusted by
moving the 3D joystick rightward or leftward.
4. Press the PLAY/PAUSE button. Record List will be dis-
played and the cursor will move to the closest date and
time.
Note: To cancel the entry form, press the MON (ESC) or
EXIT button.
Search Mode /HD500
Edit Group Alm
SEARCH
YYYY/MM/DD HH:MM
20
02 /05/07 19:32
Mon4 Cam01 R4
/HD500