Panasonic WJ-SX 150A - Manual (Page 136)

140
TIME-LAPSE VCR CONTROL [NON-PANASONIC MODELS] (TERMINAL MODE) MUX
A time-lapse VCR is operable with the system controller,
while connecting to the matrix switcher.
Notes:
• Before the use, it is necessary to install the
Multiplexer board in the matrix switcher, connect
the matrix switcher to the digital disk recorder, and
configure the system through WJ-SX150A
Administrator Console, OSD SETUP MENU, and
time-lapse VCR's SETUP MENU. [Refer to p. 32
Installing the Multiplexer Board, p. 47 Connection
with the Time-lapse VCR (Non-Panasonic Models),
p. 63 WJ-SX150A SETUP MENU (OSD), and p. 79
WJ-SX150A ADMINISTRATOR CONSOLE.]
• You cannot control non-Panasonic time-lapse VCRs
from system controllers.
The following is the procedure of a non-Panasonic model
time-lapse VCR.
■ Controlling the Time-lapse VCR
● Multiscreen Segment Switching
The operations are the same as WJ-HD500 Series.
Refer to p. 131 Multiscreen Segment Switching.
Note: 7-, 10-, and 13- segment multiscreen display are
unavailable.
● Normal Playback
1. Enter the recorder mode. (Refer to p. 131 Recorder
Mode.)
2. Do the playback procedure using the buttons on the
front panel. (Refer to the time-lapse VCR’s operating
instructions for how to operate.)
3. Press the PLAY button. The playback image will appear
on the monitor.
4. To display the spot picture, press the numeric buttons
corresponding to the desired camera number, then
press the CAM [SET] button. Then, the active monitor
number with “-H**” (** is the logical camera number)”
will appear on the LED display. (Refer to p. 132 Normal
Playback for the illustration.)
● Other Operations
Refer to the time-lapse VCR’s operating instructions for how
to operate.