Panasonic WJ-SX 150A - Manual (Page 122)

126
■ Tour Sequence
The following functions are available if a tour sequence has
been previously configured through SETUP MENU or WJ-
SX150A Administrator Console. Any tour sequence can be
assigned to any monitors.
1. Select the desired monitor. (Refer to p. 125 Monitor
Selection.)
2. To select the desired tour sequence number, press the
numeric buttons.
3. Press the SEQ button to run the tour sequence in the
forward direction on the active monitor.
4. Press the SEQ PAUSE button to pause a tour sequence
on the active monitor.
A series of camera picture appear in pause on the mon-
itor screen.
5. Press the SEQ PAUSE button again to restart a tour
sequence forward from the next step that was previous-
ly paused by pressing the SEQ PAUSE button.
6. Press the SHIFT button, and then press the + button to
move the sequence one frame to the next step from the
step that was previously paused by pressing the SEQ
PAUSE button.
Press the SHIFT button, and then press the - button to
move the sequence one frame to the previous step from
the step that was previously paused by pressing the
SEQ PAUSE button.
7. Select a camera (refer to the system controller's operat-
ing instructions) to stop the sequence. The monitor will
return to the spot mode.
■ Group Sequence
The following function is available only if a group sequence
has been previously established in WJ-SX150A
Administrator Console. The group sequence has ID num-
bers. Group 1 is 91, Group 2 is 92, Group 3 is 93, and
Group 4 is 94.
As described earlier, a group sequence determines the
assignment of monitors and cameras. Therefore, monitor
selection is not required.
1. Press the numeric buttons to select a desired group
sequence ID number.
2. Press the SEQ button to run a group sequence forward
on the assigned monitors.
3. Press the SEQ PAUSE button to pause a tour sequence
on the active monitor.
A series of camera picture appear in pause on the mon-
itor screen.
4. Press the SEQ PAUSE button again to restart a group
sequence forward from the next step that was previous-
ly paused by pressing the SEQ PAUSE button.
5. Press the SHIFT button, and then press the + button to
move the sequence one frame to the next step from the
step that was previously paused by pressing the SEQ
PAUSE button.
Press the SHIFT button, and then press the – button to
move the sequence one frame to the previous step from
the step that was previously paused by pressing the
SEQ PAUSE button.
6. Select a camera (refer to the system controller’s operat-
ing instructions) to stop the sequence. The assigned
monitors will return to the spot mode.
Note: If an alarm is activated during a sequence pause, the
sequence runs again after the unit recovers from the
alarm mode.
RUNNING SEQUENCE