Panasonic WJ-SX 150A - Manual (Page 79)

82
• Slave
Slave units and connected recorders are displayed. To
activate/deactivate Slave units, click the ON/OFF button of
a desired Slave unit. When Slave units are set to ON, their
unit names become selectable in SETUP MENU to config-
ure the parameters.
(Save Exit) button
Saves the configuration and closes the Master-Slave win-
dow.
(Cancel Exit) button
Cancels the configuration and closes the Master-Slave win-
dow.
Notes:
• If you configure the master-slave composition, settings
concerning LCN (logical camera number) and
Multiplexer Title (refer to p. 100) will be changed. When
you click on the Save Exit button, a message window
will appear to confirm you the change.
• In WJ-SX150A Administrator Console, camera channels
of the Master unit which are connected to MONITOR
OUT 1/2/3/4 of Slave units are displayed in gray. You
cannot configure the parameters.
■ Logical Camera Number
This window configures logical camera numbers assigned
to camera channels of each unit. During operation, logical
camera numbers are used for camera control and monitor
display.
To display this window, click on the (Logical Camera
Number) button in the main window (p. 80).
● How to Display
• CAM 1 to 16
This stands for a camera channel of the unit.
• Logical Camera Number
Click on each drop-down menu to select a desired logical
camera number. 1 to 99 is selectable. For camera channels
without camera connections, select “- -“.
(Save Exit) button
Saves the configuration and closes the Logical Camera
Number window.
(Cancel Exit) button
Cancels the configuration and closes the Logical Camera
Number window.
Notes:
• If logical camera numbers are not selected, the cam-
eras’ LCNs are not displayed in each window of SETUP
MENU and WJ-SX150A Administrator Console.
• You can select a logical camera number for only one
channel. When you select the same number more than
one time, a message will appear. The message will noti-
fy you that the number has been already used. If you
click on “Yes”, the newer will be activated and the older
will be changed to “- -“. If you click on “No”, the
changed parameters will return to the former state.
• If five units (Master and Slave 1 to 5) are connected in
the system, you cannot select logical camera numbers
for Master.