Panasonic WJ-SX 150A - Manual (Page 184)

12
1. Select the desired monitor. (Refer to p. 3 Monitor
Selection.)
2. Press the MENU button repeatedly until "System Status"
appears on the LCD.
3. Press the F1 button.
The SYSTEM STATUS table will appear on the active
monitor as shown in the figure.
The columns in the table indicate the states as shown in the
figure.
MON: Monitor number
CAM: Logical camera number (01 to 99)
Recorder number (R0 to R4)*
"– –" indicates that no camera is being
selected.
MODE: Lists the display mode on the
monitors.
SPOT: Spot mode
Tnn: Tour Sequence mode (nn is the
tour sequence number.)
CAM: Camera Setup mode
SET: WJ-SX150A Setup mode
ALARM: Alarm Active mode
ACK: Alarm ACK mode
VLD H: Video Loss History Table
ALM H: Alarm History Table
SYS S: System Status Table
RECORDER: Recorder mode**
KB: Lists the system controller name
(K1 to K4) or PSD.
OPE: Lists the operator number
PRI: Lists the priority number
* R0 to R4 shows the following.
Recorder number Recorder
R0 Master recorder
R1 Slave 1 recorder
R2 Slave 2 recorder
R3 Slave 3 recorder
R4 Slave 4 recorder
** When this parameter is selected, a recorder number is
displayed in the CAM area.
4. To close the SYSTEM STATUS table, press the F2 but-
ton.
5. To exit the mode, press the MON (ESC) button.
2. Perform desired operations.
q Moving the clock display
Move the 3D joystick while holding down the F1 but-
ton. (1) will move to the desired direction.
w Moving the Camera Title Display
Move the 3D joystick while holding down the F2 but-
ton. (2) will move to the desired direction.
e Moving the Event Display
Move the 3D joystick while holding down the F3 but-
ton. (3) will move to the desired direction.
r Moving the Monitor Status*
Move the 3D joystick while holding down the F4 but-
ton. (4) will move to the desired direction.
* Monitor number, controller number and monitor
mode
● Moving All the Items
1. Press the MENU button repeatedly until "OSD Position"
appears on the LCD.
2. Hold down the SHIFT button. The LCD display will
become as follows.
3. Move the 3D joystick while holding down the F1 button.
(1), (2), (3), and (4) (refer to p. 11) will move to the
desired position.
■ System Status Table
The table shows the current system status.
SYSTEM STATUS
MON CAM MODE KB OPE PRI
1 01 T01 K1 12345 30
2 99 SPOT K2 2 2
3 04 ALARM K4 4 1
4 R1 RECORDER PC 30 1
OSD Position 003
Clock Cam Event Mon
OSD Position 003
All