Panasonic WJ-SX 150A - Manual (Page 135)

139
TIME-LAPSE VCR CONTROL [PANASONIC MODELS] (TERMINAL MODE) MUX
A time-lapse VCR (Panasonic Models) is operable with the
system controller, while connecting to the matrix switcher.
Note: Before the use, it is necessary to install the
Multiplexer board in the matrix switcher, connect
the matrix switcher to the time-lapse VCR, and con-
figure the system through WJ-SX150A Administrator
Console, OSD SETUP MENU, and time-lapse VCR's
SETUP MENU. [Refer to p. 32 Installing the
Multiplexer Board, p. 46 Connection with the Time-
lapse VCR (Panasonic Models), p. 63 WJ-SX150A
SETUP MENU (OSD), and p. 79 WJ-SX150A
ADMINISTRATOR CONSOLE.]
The following is the procedure of a Panasonic model time-
lapse VCR.
■ Controlling the Time-lapse VCR
The following are the operating procedures of the time-
lapse VCR via system controllers.
● Multiscreen Segment Switching
The operations are the same as WJ-HD500 Series.
Refer to p. 131 Multiscreen Display.
Note: 7-, 10-, and 13- segment multiscreen display are
unavailable.
● Normal Playback
The operations are the same as WJ-HD500 Series.
Refer to p. 131 Normal Playback.
Note: You cannot skip to the previous/next record.
● Fast-forward
1. Press the FF button to fast-forward the tape during the
stop.
2. To stop fast-forwarding, press the STOP button.
Note: Pressing the FF button during fast-forward will
start playback.
● Rewind
1. During the stop, press the REW button to rewind the
tape.
2. Press the STOP button to stop rewinding.
Note: Pressing the PLAY button during rewind will start
playback.
● Manual Recording
The operations are the same as WJ-HD500 Series.
Refer to p. 132 Manual Recording.
● Stopping REC ONLY Alarm
Recording
The operations are the same as WJ-HD500 Series. Refer to
p. 132.