Panasonic WJ-SX 150A - Manual (Page 204)

32
WJ-HD100 SERIES CONTROL (TERMINAL MODE) MUX
Digital Disk Recorder WJ-HD100 Series are operable with
the system controller, when the Multiplexer board is
installed in the matrix switcher.
Note: Before the use, it is necessary to install the Multi-
plexer board in the matrix switcher, connect the
matrix switcher to the digital disk recorder, and con-
figure the system through WJ-SX150A Administrator
Console, OSD SETUP MENU, and WJ-HD100
Series SETUP MENU. (Refer to the operating
instructions of matrix switcher.)
■ Displaying WJ-HD100 Series
SETUP MENU
The operations are the same as WJ-HD500 Series.
Refer to p. 18 Displaying WJ-HD500 Series SETUP MENU.
The following functions and buttons are valid in SETUP
MENU.
3D joystick to the left (A): Decrements a parameter
3D joystick to the right (B): Increments a parameter
■ Controlling Digital Disk
Recorder WJ-HD100 Series
The following are the operating procedures of WJ-HD100
Series via the system controller.
● Multiscreen Segment Switching
The operating procedure is the same as WJ-HD500 Series.
(Refer to p. 19.)
Note: 7-, 10-, or 13-segment multiscreen display is unavail-
able.
● Normal Playback
The operations are the same as WJ-HD500 Series. (Refer to
p. 19.)
Notes:
• You cannot skip to the previous/next record.
• Refer to WJ-HD100 Series Operating Instructions for
details and other playback modes.
● Manual Recording
The operations are the same as WJ-HD500 Series.
Refer to p. 20.
● Stopping REC ONLY Alarm
Recording
The operations are the same as WJ-HD500 Series. Refer to
p. 20.
● Search Playback
You can search playback images using the ALARM
RECALL table or the SEARCH table.
Every time you press the SEARCH/T&D SEARCH button,
the display will change as follows.
Live image
→ Date-and-time entry form → ALARM RECALL
table → Live image
• Date-and-time Search Playback
The recorded images can be searched for through the date
and time.
1. Enter the recorder mode. (Refer to p. 19 Recorder
Mode.)
2. Press the SEARCH/T&D SEARCH button. The date-and-
time entry form will appear on the center of the monitor.
Note: The factory default setting is the current date and
time.
SEARCH
YYYY/MM/DD HH:MM
20
02 /05/07 19:32