Panasonic WJ-SX 150A - Manual (Page 131)

135
WJ-HD200 SERIES CONTROL (TERMINAL MODE)
Matrix switcher can control Digital Disk Recorder WJ-
HD200 Series. The following is the procedure of WJ-HD200
Series SETUP MENU.
Notes:
• The following operating procedures are for the terminal
mode. If you are using a PS·Data system controller,
refer to p. 143.
• When a Multiplexer board is installed in the unit, you
can neither connect nor control a WJ-HD200 Series
recorder. You need to remove the board from the unit.
■ Displaying WJ-HD200 Series
SETUP MENU
The operations are the same as WJ-HD500 Series. (Refer to
p. 130.)
■ Controlling Digital Disk
Recorder WJ-HD200 Series
The following are the operating procedures of WJ-HD200
Series via system controller.
Note: Refer to the operating instructions of Digital Disk
Recorder WJ-HD200 Series for details.
● Recorder Mode
The operations are the same as WJ-HD500 Series. (Refer to
p. 131.)
● Multiscreen Segment Switching
The operations are the same as WJ-HD500 Series. (Refer to
p. 131.)
Note: 4C-, 4D-, 7-, 10-, 13- and 16-segment multiscreen
display are unavailable.
● Normal Playback
The operations are the same as WJ-HD500 Series. (Refer to
p. 131.)
Note: You cannot skip to the previous/next record.
● Manual Recording
The operations are the same as WJ-HD500 Series. (Refer to
p. 132.)
Note: Refer to WJ-HD200 Series Operating Instructions for
details and other recording modes.
● Stopping REC ONLY Alarm
Recording
The operations are the same as WJ-HD500 Series. (Refer to
p. 132.)
● Search Playback
You can search playback images using the ALARM
RECALL table or the SEARCH table.
Every time you press the INDEX button, the display will
change as follows.
Live image
→
Date-and-time entry form
→
ALARM RECALL
table
→
Live image
• Date-and-time Search Playback
The recorded images can be searched for through the date
and time.
1. Enter the recorder mode. (Refer to p. 131 Recorder
Mode.)
2. Press the INDEX button. The date-and-time entry form
will appear on the center of the monitor.
Note: The factory default setting is the current date and
time.
F2
INDEX
SEARCH
YYYY/MM/DD HH:MM
20
02 /05/07 19:32