Panasonic WJ-SX 150A - Manual (Page 106)

109
■ Call Preset Position
1. Select the desired monitor and camera. (Refer to p. 106
Monitor Selection and p. 107 Camera Selection.)
2. To select the desired preset position number, press the
numeric buttons. (1 to 64)
3. When you have selected a wrong number, press the
CLEAR button to clear the numeric input.
4. Press the CALL PRESET button to move to the preset
position of the selected camera on the active monitor.
■ Program Preset Position
1. Select the desired monitor and camera. (Refer to p. 106
Monitor Selection and p. 107 Camera Selection.)
2. To move the camera to the position to be preset, move
the joystick and press the lens control buttons.
3. To select the desired preset position number, press the
numeric buttons. (1 to 64)
4. When you have selected a wrong number, press the
CLEAR button to clear the numeric input.
5. Press the CALL PRESET button while holding down the
SHIFT button to save a preset position of the selected
camera.
SHIFT
CALL
PRESET
PROGRAM
PRESET
PAUSE
TOUR SEQ
NEXT
AUTO PAN
PAUSE
CAM FUNC
CLEAR
LOG OUT MON LOCK
DEF ON
WIPER
DEF OFF
MON (ESC)
T&D CAM ID
MON STATUS ALL
EVENT
ALM H VLD H SYS S
CAM (SET)
MULTI SCREEN SEL
SEQUENCE
AUX2 ON AUX2 OFF EL-ZOOM
AUX1 ON AUX1 OFF STILL
Notes:
• If the entered position number has stored the previ-
ous preset position, it will be overwritten by the new
one.
• SETUP MENU and WJ-SX150A Administrator
Console can configure each operator's pan/tilt con-
trol. (Refer to p. 76 OPERATOR REGISTRATION or
p. 90 Operator Registration.)
Notes:
• To use the above function, you must set the preset
position number for the camera.
• If you press no numeric buttons or the button 0 in
Step 2, the camera will move to the home position.
CALL
PRESET
PROGRAM
PRESET
AUTO PAN
CAM FUNC
CLEAR
LOG OUT MON LOCK
DEF ON
WIPER
DEF OFF
MON (ESC)
T&D CAM ID
MON STATUS ALL
EVENT
ALM H VLD H SYS S
CAM (SET)
MULTI SCREEN SEL
SEQUENCE
AUX2 ON AUX2 OFF EL-ZOOM
AUX1 ON AUX1 OFF STILL