Polycom KIRK 14117800 User Manual
Page 97
Configuring KIRK Wireless Server 600v3 97
KIRK Wireless Server 600v3 Installation and Configuration Guide
Note:
It is recommended to select With User AC. When subscribing a new handset to
the system it is possible to use an authentication code (AC). If you want to use the
authentication code, you must select With User AC. For more information about
subscription of handsets and authentication codes, refer to
6
From the Tones list, select a ring tone.
7
Enbloc Dialing check box:
Call handler specific, refer to KWS600v3 Configuration Guide for the relevant call
handler.
8
Local R-Key/Display Handling check box:
Call handler specific, refer to KWS600v3 Configuration Guide for the relevant call
handler.
9
DTMF through RTP channel check box:
Call handler specific, refer to KWS600v3 Configuration Guide for the relevant call
handler.
10
No display of Date and Time: Enable only if time should be displayed.
11
From the Coder Preferences list, select a voice compression value that matches your
telephony infrastructure.
Contact your system administrator for more information.
12
In the Framesize fields, type the desired frame length in milliseconds and then select
either Exclusive or Silence Compression.
Contact your system administrator for more information.
Note:
If the Exclusive check box is selected for the coder, then the KWS600v3 is
forced to use the coder.
13
Click OK.
14
Click Reset (under Administration menu) to save your configuration.
7.6.1.7 Configuring DECT Master
(Primary)
On the Master page you can define which mode the KWS600v3 should operate in. You
also establish a communication protocol between the Master KWS600v3 and a call
handler.