Polycom KIRK 14117800 - Manual (Page 181)

System Management 181
KIRK Wireless Server 600v3 Installation and Configuration Guide
A dialog box appears.
3
Select the boot file in question, and then click Open.
4
Click Upload.
Wait until the system has finished updoading.
5
Click either Reset Immediately or Idle Reset.
When resetting the KWS600v3 immediately, all calls are terminated and the
KWS600v3 is reset. When resetting the KWS600v3 when the system is idle, the reset is
done when there are no active calls in the KWS600v3.
10.1.10 Resetting the KIRK Wireless Server 600v3
Some configuration changes requires a reset in order to take effect. A reset restarts the
KWS600v3 software.
You must restart the system after the following procedures:
• configuring
• uploading configuration data
• uploading firmware
• uploading radio files
• uploading boot files
There are three ways of resetting the system:
• Resetting KIRK Wireless Server 600v3 Immediately on page 181
• Resetting KIRK Wireless Server 600v3 When System is Idle on page 182
• “Resetting in TFTP Mode” on page 183
10.1.10.1 Resetting KIRK Wireless Server 600v3 Immediately
When resetting the KWS600v3 immediately, all calls are terminated and the KWS600v3 is
reset.