Polycom KIRK 14117800 - Manual (Page 41)

41
KIRK Wireless Server 600v3 Installation and Configuration Guide
Chapter 4 Installing the KIRK Wireless Server 600v3
This section provides a description of the KWS600v3 and describes how to unpack and
install it. The section also provides information about resetting the KWS600v3 hardware
using the Reset button on the KWS600v3 faceplate.
Before you install the equipment, ensure that a site planner defines the locations of the
KWS600v3.
This section contains the following information:
•
“Unpacking” on page 41
• Description of KIRK Wireless Server 600v3 on page 41
• “Installing the KIRK Wireless Server 600v3” on page 46
• “Recording the Installation Information” on page 48
4.1 Unpacking
4.1.1 Inspect for Damage
1
Inspect the shipping carton for evidence of physical damage or mishandling prior to
opening.
2 Inspect all parts for damage.
3
Report any damage to the carrier immediately.
4
If it is necessary to make a damage claim for the carrier, do not move the shipping
carton until it has been examined by a representative of the carrier.
5 Dispose of empty cartons in accordance with local regulations.
4.1.2 Unpacking the Shipping Container
For indoor installations, the following items should be present in every box containing a
KWS600v3:
• KIRK Wireless Server 600v3
• Two mounting screws and anchors
4.2 Description of KIRK Wireless Server 600v3
This section contains information about:
•
“KIRK Wireless Server 600v3 Provides RF Channels to KIRK Handsets” on page 42
• “KIRK Wireless Server 600v3 Types and Part Numbers” on page 42
• “KIRK Wireless Server 600v3 Appearance and Components” on page 42