Figure 25 – Polycom KIRK 14117800 User Manual
Page 90
90
Configuring KIRK Wireless Server 600v3
14117800, Ed.2.6
1
Under the Configuration menu, click IP.
Figure 25
Adm. Page: Configuration/IP/Settings page
2
In the TOS priority - RTP Data field, type a TOS priority.
Depending on the network, it may be necessary to change the TOS priority.
• Most networks: The default TOS priority is: 0x10
• If CISCO network: It is recommended to change the TOS priority - RTP Data to
0xb8
3
In the TOS priority - Signalling field, type a TOS priority.
Depending on the network, it may be necessary to change the TOS priority.
• Most networks: The default TOS priority is: 0x10
• If CISCO network: It is recommended to change the TOS priority - Signalling to
0x68
For information about the TOS priorities used in your network, contact you system
administrator.
4
Click Reset (under Administration menu) to save your configuration.
7.6 Configuring Multi-Cell Solution through Administration Page
Note:
Using the web based Administration Page is recommended when configuring
small to medium-sized installations.
This section describes how to configure a KWS600v3 Multi-cell solution.