2 wireless bands, 3 kirk repeater – Polycom KIRK 14117800 User Manual

Page 23

Introduction 23

KIRK Wireless Server 600v3 Installation and Configuration Guide

The KWS600v3 controls the wireless infrastructure. It manages the repeaters and the IP

interface to the call handler, as well as functionalities such as synchronization of seamless

handover, echo cancellation, line delay compensation etc.

The communication protocol between the KWS600v3 and the call handler can be either:
• Skinny
• H.323
• SIP

Note:

H.323 and Skinny Protocol support is limited to specific regions and does not

include North America

A KWS600v3 is installed directly on the LAN and must be managed as part of the

corporate network.

For more information about the KWS600v3, refer to

and

2.1.2 Wireless Bands

The wireless solution supports two wireless bands, allowing operation in various

countries and regions. Supported wireless bands are:
• ETSI DECT (1880-1900 Mhz), referred to as DECT
• USA DECT (1920-1930 Mhz), referred to as 1G9

The wireless band used by a KWS600v3 is determined by the KWS600v3 and handsets

ordered with the solution.

2.1.3 KIRK Repeater

The repeater can be used to extend the coverage area in a wireless solution. The wireless

repeater is used in areas with limited voice traffic, where cabling is difficult. Depending

on the repeater type, it can be mounted either on the wall or on the ceiling. The wall

mounted repeater is available as a half slot or full slot repeater. The ceiling mounted

repeater is available as a full slot repeater. A half slot repeater covers two simultaneous

Max. number of repeaters in a whole system

256 (minus number of

KIRK Wireless Server

primaries and secondaries

Max. number of simultaneous calls (Single-cell)

Max. number of simultaneous calls (Multi-cell)

Max. number of registered handsets (Single-cell)

Max. number of registered handsets (Multi-cell)

1500

Table 1

Overview of System Capacity

This manual is related to the following products: