Polycom KIRK 14117800 - Manual (Page 96)

96 Configuring KIRK Wireless Server 600v3
14117800, Ed.2.6
3 In the Password fields, type the passwords.
4
Select the Write Access check box.
5
Click OK.
6
Click Reset (under Administration menu) to save your configuration.
7.6.1.6 Configuring DECT System
(Primary)
1 Under the Configuration menu, click DECT, and then click System.
Figure 33 Adm. Page: Configuration/DECT/System page
2
In the Name field, the name MUST ALWAYS be DECT.
If changing the name, the system cannot operate.
3
In the PWD (password) field, type the password, and then type it again in the field
below.
4
In the Sys-Mask field, when having repeaters on the system, you must type either:
• 0x3f (up to 64)
Repeaters with higher radio ID than 64 with offset 64 will perform bearer handover.
• 0x7f (up to128)
Repeaters with higher radio ID than 128 with offset 64 will perform bearer handover.
• 0xff (up to 256)
Repeaters connected will only perform connection handover.
5 From the Subscriptions list, select either With User AC, With system AC or Disable.