6 retrieving the serial number of the kirk handset, Retrieving the serial number of the kirk handset – Polycom KIRK 14117800 User Manual
Page 73
Preparing KIRK Handset for Use 73
KIRK Wireless Server 600v3 Installation and Configuration Guide
6.5.2.2 KIRK 5020 / 5040 Handsets
When charging the battery for the first time, it is necessary to leave the handset in the
charger for 14 - 16 hours before the battery is fully charged and the handset ready for use.
Note:
During normal operation, it takes approximately four hours to charge the handset
from fully discharged to its full capacity.
•
Place the handset in the charger.
For correct charging, be sure the room temperature is between 0°C and 40°C/32°F
and 104°F. Do not place the handset in direct sunlight. The battery has a built-in heat
sensor which will stop charging if the battery temperature is too high.
If the handset is turned off when placed in charger, nothing indicates the charging.
There will be no reaction for incoming calls.
If the handset is turned on when charging, the display shows a blue charging icon.
The charging icon turns green when fully charged (when handset is removed from
charger, the charging icon disappears). It will not vibrate. B-answer is inactive. The
handset reacts normally for incoming calls.
It is necessary to recharge the battery when the handset display shows the battery low
icon, or if the handset cannot be turned on.
6.6 Retrieving the Serial Number of the KIRK Handset
To enable service to the handset, the serial number must be programmed into the system
database via the web based Administration Page of the KWS600v3. (For more
information, refer to
The serial number (IPEI number) of each handset is found either on a label, which is
placed behind the battery, or on the packaging label.
To show the serial number on the handset display (3040 Handset/4020 Handset/4040
Handset and 4080 Handset), press *99984*, and then press
3
; the serial number appears
on the handset display. Press < for 5 seconds to exit the menu.
To show the serial number on the handset display (5020 / 5040 Handset), press
Menu,
select Status and then select Firmware version. Press exit to exit the menu.