Figure 37, Figure 38 – Polycom KIRK 14117800 User Manual
Page 101
Configuring KIRK Wireless Server 600v3 101
KIRK Wireless Server 600v3 Installation and Configuration Guide
1
Under the Configuration menu, click ETH0, and then click DHCP.
Figure 37
Adm. Page: Configuration/ETH0/DHCP page
2
From the Mode list, select Disabled, and then click OK.
3
Click Reset (under Administration menu) to save your configuration.
4
Under the Configuration menu, click ETH0, and then click IP.
Note:
It is necessary to use the ETH0 port when integrating the KWS600v3 on the
local network.
Figure 38
Adm. Page: Configuration/ETH0/IP page
5
In the IP address field, type the new IP address.
The new IP address is now the default address when accessing the KWS600v3.
6
In the Network mask field, type a new network mask.
7
In the Default gateway field, type the IP address of the default gateway.
Contact your system administrator for more information.
8
Click OK.