Printronix ThermaLine Series - Manual (Page 90)

Commands 4–46
Duplication, Vertical
Purpose Defines both the number of times elements are duplicated vertically and the
spacing between each duplication.
Mode CREATE
Format VDUP; dup#; offset#
elements to be duplicated
VDUP;OFF
VDUP The Vertical Duplication command; enter VDUP.
dup# Specifies the duplication number – the number of times
the entered form element(s) will repeat vertically. Enter
a value ranging from 1 to 255.
offset# Specifies the vertical offset to establish the vertical
spacing between each duplication of the form
element(s) specified in the body of the command.
Enter a value in terms of dot or character columns
based on the Scale command (page 4–88), or use the
CP.DP format (page 4–7). The offset is from starting
row to starting row.
VDUP;OFF Terminates the Vertical Duplication command; enter
VDUP;OFF. If not entered, the IGP/PGL expects
another form element to be defined for duplication. A
single VDUP command can define different types of
elements for duplication.