Printronix ThermaLine Series - Manual (Page 199)

5–61 Bar Codes
SR Defines the starting row for the bar code. Enter a value
ranging from row 1 to one less than the length of the
form. Character row or dot row is specified based on
the Scale command (page 4–88), or use the CP.DP
format (page 4–7).
SC Defines the starting column of the bar code. Enter a
value ranging from column 1 to one less than the width
of the form. Character column or dot column is
specified based on the Scale command (page 4–88), or
use the CP.DP format (page 4–7).
D The printable character (delimiter) identifying the start
and finish of the data field. Enter any printable
character other than a slash (/), the SFCC, or a
character used within the data. The same character
must be used at both ends of the data field, but it will
not print with the data.
data field The characters of the bar code data are restricted to
exactly seven digits. If the 2– or 5–digit add–on data
option is used, include this data at the end of the data
field. The characters available for the data field are 0
through 9 (30 through 39 hex, respectively).
PDF Optional parameter to print the human readable data
field. The data field prints automatically unless the
PDF–suppress command is specified in the FONT
parameter. The human-readable data field can be
printed above or below the bar code symbol.
This parameter is not allowed if a null data field is
specified. If no PDF command is entered, the data
field will print automatically in the default OCR–B
font.
LOC Optional parameter to identify the location of the
printable data field. The default value is B, locating the
human readable data below the bar code. A locates the
printable data field above bar code. To compensate for
printing the 0.1–inch high data, the height of the bar
code body is reduced 0.1 inch.