Printronix ThermaLine Series - Manual (Page 220)

Bar Codes 5–82
SR Defines the starting row for the bar code. Enter a value
ranging from row 1 to one less than the length of the
form. Character row or dot row is specified based on
the Scale command (page 4–88), or use the CP.DP
format (page 4–7).
Defines the starting column of the bar code. Enter a
value ranging from column 1 to one less than the width
of the form. Character column or dot column is
specified based on the Scale command (page 4–88), or
use the CP.DP format (page 4–7).
D The printable character (delimiter) identifying the start
and finish of the data field. Enter any printable
character other than a slash (/), the SFCC, or a
character used within the data.
The same character must be used at both ends of the
data field, but it will not print with the data.
data field Enter the characters for the bar code data. A null data
field (no characters) is permitted. The length of the
data field is variable; however, the maximum length is
usually limited to 32 characters to minimize potential
reading errors.
For German I-2/5, however, data length should be
either 11 or 13.
For regular I-2/5, an even number of characters is
required for the interleaving process. Consequently, if
an odd number of characters are entered in the data
field, a leading zero is added automatically.
The characters available for the data field are 0 through
9 (30 through 39 hex, respectively).
PDF Optional parameter to enable printing of the human
readable data field. Enter PDF to print the data field. If
the parameter is not used, the human readable data is
not printed.
This parameter is not allowed if a null data field was
specified.