Printronix ThermaLine Series User Manual
Page 20
1–8
Introduction
Table 1–1. Normal Mode Commands
Command
Mnemonic
Description
Page #
Compressed Print
DENSITY
Defines the horizontal print density in characters per inch (cpi).
4–33
Configuration
CONFIG
Reconfigures IGP/PGL parameters.
4–34
Create
CREATE
Places the IGP/PGL in the Create Form mode where all the Create Form mode
commands are available to design form elements.
4–39
Create Logo
LOGO
Places the IGP/PGL in the Create Logo mode, where logos can be defined using
the appropriate dot placements.
4–74
Delete Form
DELETE FORM
Deletes a selected form name from the directory and IGP/PGL memory.
4–41
Delete Logo
DELETE LOGO
Deletes a selected logo name from the directory and IGP/PGL memory.
4–42
Directory
DIRECTORY
Provides a list of all defined forms and logos, logo assignments to forms, and
memory usage and availability.
4–43
Execute
EXECUTE
Executes a previously created form.
4–49
Expanded Print
EXPAND
Expands fonts vertically and horizontally.
4–60
Font
FONT
Selects a specific typeface, bold, slant (italic) factor, and symbol set.
4–61
Ignore Sequence
On/Off
IGON
IGOFF
Enables the IGP/PGL to ignore all characters after the Ignore Sequence On
command is sent until the Ignore Sequence Off command is sent. See Note on
Page 1–11.
4–65
Line Spacing,
Vertical
LPI
Defines the lines per inch (lpi) printing format.
4–66
Listen
LISTEN
Removes IGP/PGL from the quiet state and enables IGP/PGL operation.
4–71
Multinational
Character Set
USET
ISET
Use a multinational character set or create a custom user–defined character set.
Chapt. 6
Normal Mode
NORMAL
Places the IGP/PGL in the Normal mode, where it does not change the data
stream but awaits the SFCC followed by an IGP/PGL command.
4–77
Paper
PAPER
Selects features such as paper cutter, print intensity, label sensor, page
orientation (portrait/landscape), and print speed.
4–79
Print File
Prints a file from external memory
4–83
Quiet
QUIET
IGP/PGL operation is disabled until a Listen command is received. Any data
sent to the LinePrinter Plus Emulation is unaffected by IGP/PGL commands.
4–84
Reset
RESET
Deletes all forms and logos from the IGP/PGL memory.
4–85
Select Format
On/Off
SFON
SFOFF
Ignores all host–generated paper movement commands. See Note on Page
1–11.
4–90
Set Up
SETUP
Automatically executes and loads the IGP/PGL commands into the printer at
power–up or after a RESET command is sent.
3–2
Printer Mode
PMODE
Included only for compatibility; not recommended for use.
N/A
Scaling Mode
SMODE
Included only for compatibility; not recommended for use.
N/A