Printronix ThermaLine Series - Manual (Page 129)

4–85 Commands
Reset
Purpose Deletes all forms and logos from IGP/PGL memory. The Reset performs
the following tasks:
•
Prints any objects in the current page
•
Selects the portrait orientation
•
Deletes all forms and logos resident in memory
•
Sets the font to the default Gothic 12 point/10CPI
•
Releases all user–defined character mappings
•
Runs the SETUP file if present
Mode NORMAL, CREATE, or EXECUTE
Format (cc)RESET
(cc) The Special Function Control Character.
RESET The Reset command; enter RESET.
Comments This command deletes all forms and logos, including those input by other
operators on shared IGP/PGL systems. To prevent the loss of information
contained in the 2K–byte input buffer of the serial interface, the Reset
command sequence must be the last item sent to the printer.
IMPORTANT
Wait several seconds after issuing a RESET command before sending
another IGP/PGL command. The RESET process must be thoroughly
completed before new IGP/PGL data is sent, or new data may be lost or
damaged.