Printronix ThermaLine Series - Manual (Page 34)

2–4 Configuration
Define CR Code (Carriage Return)
This parameter forces the printer to insert an automatic Line Feed code into
the data stream whenever a Carriage Return code occurs. This is to be used
only if the host computer does not send Line Feeds to the printer.
•
CR = CR. The default. Does NOT perform a line feed. The next print
position will be print position 1 of the current line.
•
CR = CR + LF. Performs an automatic line feed. The next print
position will be print position 1 of the next line.
Define LF Code (Line Feed)
This parameter forces the printer to insert an automatic Carriage Return code
into the data stream whenever a Line Feed code occurs. This can be used in
most installations, but it is required if the host computer does not send
Carriage Returns to the printer.
•
LF = LF. The default. Does not perform an automatic carriage return.
The next print position will be the current print position of the next line.
•
LF = CR + LF. Performs an automatic carriage return. The next print
position will be print position 1 of the next line.
Autowrap
This parameter determines if text will wrap to the next line when the line of
text exceeds the right margin.
•
Disable. The default. Truncates the text beyond the right margin until a
CR or CR+LF is received.
•
Enable. Automatically inserts a CR+LF after a full print line.
Select SFCC
You can specify which decimal code (1–255) will be used as the Special
Function Control Character (SFCC). The factory default setting is 126 (~).
The SFCC denotes that the following data is an IGP/PGL command.