Printronix ThermaLine Series - Manual (Page 88)

Commands 4–44
Duplication, Horizontal
Purpose Defines both the number of times form elements are duplicated horizontally
and the spacing between each duplication.
Mode CREATE
Format HDUP; dup#; offset#
elements to be duplicated
HDUP;OFF
HDUP The Horizontal Duplication command; enter HDUP.
dup# Specifies the duplication number, which is the number
of times the entered form element(s) will repeat
horizontally. Enter a value ranging from 1 to 255.
offset# Specifies the horizontal offset to establish the
horizontal spacing between each duplication of the
form element(s) specified in the body of the command.
Enter a value in terms of dot or character columns
based on the Scale command (page 4–88), or use the
CP.DP format (page 4–7). The offset is from starting
column to starting column.
HDUP;OFF Terminates the Horizontal Duplication command; enter
HDUP;OFF. If not entered, the IGP/PGL expects
another form element to be defined for duplication. A
single HDUP command can define different types of
elements for duplication.