Printronix ThermaLine Series - Manual (Page 84)

Commands 4–40
FL The optional forms length parameter to specify the
maximum length of the form. (Form length cannot
exceed the physical length of the page. Refer to
Appendix C). Specify the form length in one of three
ways:
a. Enter 0 to define a form of unspecified length.
The form will end after the longest element; that
is, the form length is automatically controlled to
contain all elements without extra length beyond
the longest element. This can be used to
eliminate wasted paper after producing short
forms.
b. Enter a value for the form length ranging from 1
to 65,535 to specify the forms length in dot
rows. (12 dot rows per line = 6 lpi spacing; 9 dot
rows per line = 8 lpi spacing.)
NOTE: Dot row range for setting the forms length depends on the forms
length configuration. Refer to page 4–64 for information on how to
configure the forms length.
When the host form length configuration option is enabled, the form
length and width values defined in this command, set the physical
length and width page size.
c. To specify the default forms length of 792 dot
rows (11 inches at 6 lpi), do not enter a value in
the form length parameter.
DISK Optional parameter to store the form on the IGP/PGL
external memory module. Enter DISK.
Example The following command creates a form named ORDER with the default
forms length:
(cc)CREATE;ORDER