Printronix ThermaLine Series - Manual (Page 356)

Error Codes 8–24
Font Errors
160 FONT command parameter error
The FACE # parameter is either missing a space between the parameter and
its value, or a semicolon is missing between font parameters.
161 Illegal FONT typeface value – must be (9)0000–(9)9999
An illegal FONT typeface value was used. FONT typeface values range from
90000 to 99999, or 0 to 9999.
162 Illegal FONT bolding factor – must be ON(1) or OFF(0)
An illegal FONT bolding value was used. ON (or 1) or OFF (or 0) must be
entered.
163 Illegal FONT slant – must be LEFT (–1), OFF (0), or RIGHT (1)
An illegal FONT slant value was used. LEFT (or –1), OFF (or 0), or RIGHT
(or 1) must be entered.
164 Illegal FONT point size – must be 4–999
An illegal FONT point size was used. Valid values range from 4 to 999.
165 Illegal FONT symbol set value
An invalid SYMSET parameter value was used. Valid parameter values are 0
to 31.
166–169 Not defined.
170 PAPER command syntax error
171 Invalid PAPER parameter error – out of range