Lucent Technologies P550 User Manual

Page 48

Configuring the Cajun P550 Switch (Layer 2 & Layer 3)

3-2

Cajun P550/P220 Switch Operation Guide

To configure the supervisor module using the CLI:

1. Attach a serial cable from your PC’s serial port to the serial port of the supervisor

module front panel (refer to Figure 3-1) using a 9-pin straight-through
male-to-female serial cable (refer to “Switch Features,” earlier in this guide for
pinout information).

2. Run a terminal emulation program (HyperTerminal, for example) on the attached

PC. Ensure that the terminal settings match those listed in Table 3-1.

3. Power up the switch by turning on the power supplies. In the terminal emulation

program, the switch displays the following startup messages:

Booting the operational system, please wait ....

Initializing the file subsystem ... done

Initializing the event subsystem ... done

Initializing the agent subsystem ... done

Initializing the platform ... done

Initializing the switch subsystem ... done

Starting up threads ...

Periodic Task

Event

Network Interface

Switch Interface

Telnet Processes

Ping Process

Module Manager

Address Table Aging

Multicast Pruning

Front Panel Display

Download

Fans Poller

Power Supplies Poller

VTP Snooping

Redundant Controller/Element Poller Task

Command Line Parser

Powering up modules

Module 1 Powered

Waiting for power cycle to complete (

The 17 second power cycle option

)

Module 2 Powered

Initializing the module subsystem ... done

System initialization complete.

Configuring system from Startup Config file [/nvram/startup.txt] ... done

Boot process complete - system is now operational.(3.0->4.0 conversion)

Creating Startup Config file [/nvram/startup.txt] ... done

This software is furnished under a license and may be used in accordance

with the terms of such license and with the inclusion of the above