Lucent Technologies P550 - Manual (Page 133)

Configuring IP Routing (Layer 3)
Cajun P550/P220 Switch Operation Guide 7-7
5. Click CREATE to save changes, or CANCEL to restore previous settings.
Note: Routing is not supported on the serial interface. Do not configure
Routing/Mgmt on serial IP interfaces.
IP Multinetting
Using the Cajun P550 switch, you set up IP multinetting—a configuration of multiple
subnets on a single VLAN. A network is said to be multinetted (Figure 7-1) when
multiple logical groups of computers are brought together within a single broadcast
domain. To create a multinetted network, you assign multiple subnets to a VLAN.
Figure 7-1. Multinet Diagram
NetBIOS UDP
Rebroadcast Configure your switch for InterVLAN forwarding of NetBIOS
broadcasts. NetBIOS parameters include:
• Inbound - Allow the receipt of NetBIOS replies.
• Outbound - Allow the transmission of NetBIOS
broadcasts.
• Both - Allow the interface to both receive NetBIOS
replies and send NetBIOS broadcasts.
• Disable - Disallow both the receipt of NetBIOS replies
and the transmission of NetBIOS broadcasts.
VRRP Enable or disable VRRP on a given interface. The default
value is Disable.
Table 7-3. IP Interfaces (Continued)
Parameter Allows you to...
Cajun
192.168.10.0
PC
PC
VLAN
Ethernet
segment
Server Ports
192.168.60.0