Lucent Technologies P550 - Manual (Page 288)

Downloading New Operational Code to the Switch (Layer 2 & Layer 3)
18-4 Cajun P550/P220 Switch Operation Guide
Selecting the Image for Reboot
To view and power up the downloaded image from the Web Agent:
1. In the Memory Subsystems section, click FEPROM Contents. The FEPROM
dialog box opens.
2. In the Power Up/Reset Image pull-down menu, select the APP location into
which you downloaded version 4.0 and click APPLY.
To set the location from which you download the software through the command line,
enter the following command at the system prompt on version 3.0 or 3.1:
fep set
where is the APP location in flash memory on the switch that contains the
new image.
Resetting the Switch
To reset the switch through the Web Agent after downloading version 4.0:
1. In the System Information section of the Web Agent, click System Reset.
2. In response to the question, Do you want to reset the switch? click Yes.
The switch resets with the selected version.
To reset the switch through the command line interface after downloading version 4.0:
1. At the system prompt, enter the following command:
reset
2. In response to the question, Are you sure you want to continue? enter Y.
The switch resets with the selected version.